Okat so I'm running TD13.10 with Viewpoint 14.01. I have setup 3 Utilitiy limit control's as below
Loads: which is all types of loads with limit of 5.
Exports: which is all types of exports with limit of 10.
All Utils: which is for loads and exports with a limit of 10.
This allows for the following to happen.
5 loads and 5 exports
0 loads and 10 exports
2 loads and 8 exports
or any combination of above
My question is in Qeury session portlet I can see sessions delayed in DELAY filter linked to the above show when I click on delay tab after drilling down on a session but do not understand what the SESDELAYED tab is for. From my reading of the manual it should be due to the above limits I have set.
Can someone explain what causes a session to go into the SESDELAYED filter.
Forums: